PSEL wraps up testing on non-reflective solar panels for arrays in glare-sensitive locations July 15, 2020 4:43 pm Published by Kelly Sullivan Sandia National Laboratories’ Photovoltaic Systems Evaluation Laboratory (PSEL) is in the final phase of a collaborative research project with Nishati, a veteran-run manufacturer of light-weight, portable photovoltaic panels. In 2016, Nishati sought Sandia assistance through the U.S. Department of Energy Small Business Vouchers (SBV) program to scale up its portable PV system into utility-grade equipment. The portable equipment was designed to meet stringent Marine Corps requirements to minimize reflective glare for pilots in tactical environments. “These same requirements could be useful at military air bases and airports,” said Dr. Bruce King, the PI on the project. Nishati project PI Dr. Bruce King at Sandia’s Photovoltaic Systems Evaluation Laboratory (PSEL) Once Nishati was awarded a voucher, work took place in three phases. Phase I included materials screening activities using mini-modules to assess different packaging materials and surface textures, King said. “Glare testing was performed at the National Solar Thermal Test Facility (NSTTF),” the PI said, “and electrical response was tested at PSEL to determine the optimal materials package to use for the product.” Phase II included scaling up the mini- module designs to three, prototype utility-grade, 72-cell photovoltaic panels. These were also sent to the NSTTF to validate reflectivity, King said. Results from this testing were added to the SNL-developed Solar Glare Hazard Assessment Tool, now GlareGauge™ to assist with PV plant design near airfields. The prototypes were then brought back to PSEL for indoor and outdoor electrical characterization, he said. King said Phase II results showed that while the electrical performance of the panels was undifferentiated from commercial products currently on the market, the panels’ reflectivity results were unbelievably better. “The products’ electrical performance was indistinguishable from anything I might read on any spec sheet,” said King, “but what was significant was the reduced reflectivity. We knew from testing for SGHAT that reflectivity was low but we weren’t expecting to see it translate into potential power gains compared to conventional products.” In Phase III of the project, a second set of panels similar to the Phase II panels are being used to validate the results. “We’ll take the output from the validation studies and run power prediction simulations to understand the potential magnitude of these gains for different system configurations,” King said. Phase III will conclude at the end of FY19 with the two sets of panels installed outdoors in side by side systems at PSEL to validate the simulations. The panels will be connected to the grid for a year or more, King said, and will also provide valuable information about their durability. As the SBV project comes to a close, the modules will transition into PSEL’s PV Proving Grounds project, where researchers can continue to learn about their unique behavior, he said. « Previous Next » Comments are closed here.